Stihl FS 310 Instruction Manual page 21

4
3
2
b
a
Place the cutting attachment (1) in
N
position.
WARNING
Collar (a) must locate in the cutting
attachment's mounting hole (b).
Fit the thrust washer (2) – convex
N
side must face up.
Fit the rider plate (3) (for mowing
N
applications).
Block the drive shaft.
N
Screw on the nut (4)
N
counterclockwise and tighten it
down firmly.
NOTICE
Remove the tool used to block the shaft.
FS 310
Removing the cutting attachment
Block the drive shaft.
N
Unscrew the mounting nut
N
clockwise.
Pull the cutting attachment with its
N
1
mounting hardware off the gearbox.
WARNING
If the mounting nut has become too
loose, fit a new one.
Shredder Blade 270-2
Mounting the cutting attachment
Fit the guard ring for mowing
N
applications.
4
2
b
b
a
Place the shredder blade (1) in
N
position – the cutting edges must
point upwards.
Collar (a) must locate in the cutting
attachment's mounting hole (b).
N
N
N
N
Remove the tool used to block the shaft.
Removing the cutting attachment
N
N
N
3 3
1
If the mounting nut has become too
loose, fit a new one.
WARNING
Fit the thrust washer (2) – convex
side must face up.
Fit the guard ring (3).
Block the drive shaft.
Screw on the nut (4)
counterclockwise and tighten it
down firmly.
NOTICE
Block the drive shaft.
Unscrew the mounting nut
clockwise.
Pull the cutting attachment with its
mounting hardware off the gearbox.
WARNING
English
19