Bosch TDA 56 series Operating Instructions Manual page 13

Trouble shooting guide for minor issues
Problem
The iron does 1. Temperature control
dial in very low position.
not heat up.
2. No mains supply.
The lamp at 1. The iron is cooling.
2. The iron does not heat
the back of the
up.
water tank does
not switch on
The clothes 1. The temperature is too
high.
tend to stick.
Water comes 1. Temperature regulator
in very low position.
out together
2. Steam regulator in very
with steam.
high position with low
temperature.
Steam does not 1. Steam regulator in
come out. closed position
2. No water in the tank.
3. The temperature is too
low. Anti-drip system
not activated.
Spray does not 1. No water in the tank.
2. Obstructed
work.
mechanism.
Water drips out 1. The steam regulator is
not properly closed.
of the soleplate.
Smoke comes 1. Lubrication of some of
the internal parts.
out when
connecting the
iron for the first
time.
You can download this manual from the local homepages of Bosch
Probable cause
.
Solution
1. Turn to a higher position.
2. Check with another appliance
or plug the iron into a different
socket.
1. Wait until the heating cycle is
completed.
2. See previous paragraph.
1. Turn the temperature control dial
down and wait until the iron has
cooled down.
1. Turn the temperature control dial
regulator to a higher position and
wait until the operating indicator
switches off.
2. Turn the steam regulator to a
lower position.
1. Turn the steam regulator to an
open steam position.
2. Fill the tank.
3. Set a higher temperature if
compatible with the fabric.
1. Fill the water tank.
2. Contact the Technical Service.
1. Ensure the steam regulator is set
to the position .
Do not forget to empty the tank
when you have finished ironing.
1. This is normal and will stop after a
few minutes.
en
13