Panasonic WV-CW480S Operating Instructions Manual page 39

• Image stabilization may not function where there is excessive camera movement or when
the scene is low light or low contrast objects.
16. LENS
Select PANASONIC.
17. Back-focus Setting (BACK-FOCUS SETUP)
Perform adjustment of the back-focus (flange-
back: the gap between the lens and focal plane)
remotely on this menu using a system controller.
After installation, you can perform this adjustment
when defocus arises that may be caused by
long-term use, environmental changes, etc.
Important: Do not use the ABF function for con-
tinuous or repetitive purposes (ex. autofocus
etc.). This function is to be used to correct
defocus caused by switching between colour
and black - and - white when/after installing
the camera.
1. Select BACK-FOCUS on the top menu and press the [SET] button.
→ The BACK-FOCUS SETUP menu opens.
2. Select ABF and press the [SET] button.
→ Adjustment is automatically performed.
Notes:
• Performing ABF will function to obtain the best focus around the centre areas in a
scene.
• Performing ABF is available only when OFF, X2 AUTO, or X2 FIX is selected for SENS
UP.
• Using the ABF function under low light conditions may cause noise.
3. Select MANUAL-ADJ and press the [SET] button if manual adjustment is required.
The manual back-focus adjustment screen will open.
• Use the [LEFT] or [RIGHT] buttons to move the "I" cursor and obtain a proper focus.
→ Refer to the 4-digit number on the second bottom line. The larger the number is, the bet-
ter the focus will be.
• Select RET and press the [SET] button to go back to the menu setup.
**BACK-FOCUS SETUP**
→PUSH SW
ABF
MANUAL-ADJ
C/L← → B/W
AUTO
SETUP-SW LOCK OFF
NEAR
.........I.........
INDICATOR XXXX
RET TOP END
FAR
39