Advertisement
Using one amplifier for each speaker
Make sure that the amplifiers are identical.
1. Unscrew both sets of terminals and remove the jumper
2. Connect the cables from the bottom set of terminals to
3. Connect the cables from the top set of terminals to the
4. Repeat steps 2 and 3 above for the second amplifier.
Using with a multichannel Surround Processor
1. Select the Large setting on your receiver or processor
2. Match the sound levels of each speaker. Your home
10
straps.
the first amplifiers right channel.
first amplifiers left channel.
for your main speakers. This routes all bass information
(typically below 100Hz) to your XA Towers.
theater system most likely includes a test signal that
simplifies level matching. Refer to the instructions
provided with these electronics.
XA Reference
XA Reference
speaker
terminal
jumpers
input
center
L
preamp
outputs
R
front surround
sub
amplifier
amplifier
surround processor
Advertisement
