Samsung HG75AD690U Installation Manual page 28

y The RJP can be returned to the factory default settings by pressing the A/V and HDMI buttons simultaneously for 10
seconds. All LEDs blink 5 times to acknowledge that this has been finished.
y The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room. The
LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer will restart. If the
guest then touches another source button, the TV will change to the selected source and the corresponding LED will be lit.
y After an RJP Reset or a TV Power OFF/ON, it takes approx. 10 seconds to establish communications between the TV and
the RJP.
y The following table shows the approximate time in seconds to switch from the TV to the input source, based on the priority.
✎ Scenario 1: When no inputs are connected.
Source
AV
HDMI
✎ Scenario 2: When two or more inputs are connected and an Input source is disconnected and then reconnected.
Source
AV
HDMI
✎ E.g. If the RJP has all its live sources AV and HDMI connected, AV is viewed as the highest priority. If the RJP is in
HDMI mode, and a guest removes and reconnects the AV, the minimum time required to switch to the AV is 6.5
seconds.
y To connect audio (Ipod or Mp3), Music mode should be ON.
y A/V and HDMI input sources are supported.
28
English
To Connect
2 Sec
3.9 Sec
Disconnect To Connect
4.5 Sec 2 Sec
3.9 Sec 3.9 Sec
Total
6.5 Sec
7.8 Sec