Advertisement
Basic operation (to be continued)
The way to adjust Brightness, contrast, backlight, color temperature and scale
mode,please refer to "Adjusting the Picture" on Page15 -16.
Note: If the TV turn to standby mode for VGA non-signal state, then you input a signal
to VGA terminal, it will wake up to work.
2.Window
This TV supports no higher than 60Hz under VGA mode, so please set the re
fresh rate of PC to 60Hz. If the frequency is higher than 60Hz, the screen may
flicker. When the TV is in VGA mode, press MENU button on the remote control.
Press
/
Arrow button to select "Window".
PICTURE
AUDIO
SETTING
H-POSITION
V-POSITION
CLOCK
PHASE
AUTO ADJUST
ADJUST
SELECT
1)
Adjusting picture H-Position
Press
/
Arrow button to select "H-Position" and press
set horizontal position of picture.
2)
Adjusting picture V-Position
Press
/
Arrow button to select "V-Position" and press / Arrow button to set
vertical position of picture.
3)
Adjusting Clock
When PC is connected to TV set because of the difference of PC parameter,you
should adjust the "Clock" item in "Window" menu until you get a good picture.
4) Adjusting Phase
When PC is connected to TV set because of the difference of PC parameter,you
should adjust the "phase" item in "W indow" menu until you get a good picture.
5) Auto Adjust
If there are unexpected problems happened when you adjust the items, you can
select the "Auto Adjust" and press
original settings.
Note: Only "H-Position" and "V-Position" are available for Ypbpr mode.
20
FUNCTION
WINDOW
PICTURE
100
H-POSITION
100
V-POSITION
100
0
MENU
EXIT
ADJUST
Arrow button, the TV set will resume the
AUDIO
SETTING
FUNCTION
WINDOW
100
100
SELECT
MENU
EXIT
/ Arrow button to
Advertisement
