Panasonic BL-C20 Operating Instructions Manual page 19

Camera Feature Locations
Front View
FACTORY DEFAULT
RESET Button
Indicator Display
Power
on
Normal Operation*
Automatic
Setup
Finished setting
Using Getting IP address*
DHCP
Got IP address
Updating Firmware
FACTORY DEFAULT RESET
button pressed
TM
UPnP
Internal Failure
* The information below varies depending on the indicator settings (see page 110).
1
* The indicator turns orange if the camera is not connected to the LAN.
2
* The indicator blinks orange if the camera is not connected to the LAN.
3
* See page 4 of Troubleshooting on the CD-ROM.
4
Antenna
*1
Not on LAN
On LAN Orange
2
Setting
3
(The camera is reset to factory default status after 1 minute.)
Failure
Orange
Orange blinking
Green blinking
Orange blinking
Orange blinking
Orange blinking
The status when turned on
Orange blinking (About a 2-second interval)
Red blinking*
Operating Instructions
Indicator
The indicator color
shows camera status.
Lens
(0.3 m—Unlimited)
Orange blinking
Green blinking
Green
Green
Green blinking
Green
Turning off (about 5 seconds)
4
Green
19