Table of Contents
Advertisement
Cleaning the Unit
3
Use
the
(KV-SS03) to remove the dirt from the
surfaces of the retard roller, paper feed
roller, separation roller, 6 drive rollers,
6 free rollers. Also, remove dust on the
paper sensors and reflector sheets
with a cotton swab.
≥ When wiping off the dirt on the roller sur-
faces, hold the rollers to prevent them
from rotating, and wipe the rollers all the
way around them proceeding from one
end to the other in the directions of the
arrows shown in the figure on the right.
4
Clean the reflector sheet for the ending
sensor.
≥ Remove dust on the reflector sheet of the
ending sensor with a cotton swab.
≥ The reflector sheet is behind the shaft.
24
roller
cleaning
paper
Paper detector
Retard roller
Drive rollers
Waiting sensor
Free rollers
Starting position sensor
Reflector sheets
Drive rollers
Paper feed roller
Separation roller
Free rollers
Reflector sheet
for ending sensor
Cotton swab
Advertisement
Table of Contents
