Subscribe to Our Youtube Channel
Related Manuals for BETCO fibercap 20
Summary of Contents for BETCO fibercap 20
- Page 1 E29975-00 FiberCAP 20” Carpet ™ Cleaning Machine Operator Manual 1001 Brown Avenue • Toledo, Ohio 43607-0127 Customer Service: 888-GO-BETCO • Fax: 800-445-5056 • Technical Service: 877-856-5954 • www.betco.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS RECEIVING THE MACHINE..........3 TECHNICAL SPECIFICATIONS ........3 GENERAL SAFETY REGULATIONS ......... 4 MACHINE PREPARATION ..........5 OPERATION ..............6 - 7 USE OF MAINTENANCE TIPS ......... 8 PARTS DIAGRAMS AND LISTINGS ......9 - 11 WARRANTY ..............12... -
Page 3: Receiving The Machine
RECEIVING THE MACHINE Immediately check, when receiving the machine, that all the materials indicated on delivery documents have been received and also that the machine has not been damaged in transit. If it has been damaged, this damage must be immediately reported to the shipper and also to our customer service department. -
Page 4: General Safety Regulations
• Before using the machine make sure that all doors and covers are positioned as shown in this operating and maintenance manual. • When your BETCO machine is ready to be retired, the machine must be disposed of properly. It contain oils and electronic components. The machine was built using totally recyclable materials. -
Page 5: Machine Preparation
MACHINE PREPARATION 1. ASSEMBLING THE HANDLE The handle assembly is comprised of four individual parts. A. Install the main cross bar onto the machine by pulling the finger pins outward on both sides and locking them into the handle mounts of the machine. -
Page 6: Operation
MACHINE OPERATION 1. STARTING THE MACHINE A. Attach the extension cord to the plug on the machine. B. Insert cord through strain relief holder. C. Plug into a grounded 110V/120V outlet. D. Push down the start lever on the left side of the machine. The machine will automatically start when the handle is lowered to an operating position. - Page 7 Follow these steps for interim encapsulation cleaning of carpet: A. Install the dust collection bins on the machine and sweep the carpet to remove any large and loose debris. B. In a spray bottle or pump sprayer dilute the Betco FiberCap™ MP ®...
-
Page 8: Use Of Maintenance Tips
USE AND MAINTENANCE TIPS 1. REMOVAL OF BRUSHES AND CLEANING THE MACHINE After each use, the brushes should be removed and cleaned. The underside of the machine should be cleaned as well. A. Disconnect the power supply from the machine. B. -
Page 9: Parts Diagrams And Listings
PARTS DIAGRAM... - Page 10 PARTS LISTING PARTS LISTING Item # Part # Description Item # Part # Description E84600 Snapring E84600 E84641 Snapring Screw, M5 x 45 E84642 Clamp Strip E84607 Bearing E84607 Bearing E84644 Cable Clamp E84601 Motor Spacer E84601 Motor Spacer E84602 Roll Pin E84602 E84645...
- Page 11 PARTS DIAGRAM & LISTING PARTS DIAGRAM & LISTING PARTS DIAGRAM & LISTING Item # Part # Description Item # Part # Description E84659 Handle Bar, Upper Section E84659 Handle Bar, Upper Section E84660 Handle Base Cross Bar E84660 Handle Base Cross Bar E84661 Handle T-Mount, Left E84661...
-
Page 12: Warranty
Service Distributor. If the original part is returned within the warranty policy period from date of delivery for inspection by Betco and is found to be defective the owner will be credited for the cost of replacement parts plus shipping and handling.
Need help?
Do you have a question about the fibercap 20 and is the answer not in the manual?
Questions and answers