Details of your projector (continued)
Rear and bottom view
①
③
① Terminals
② Remote control signal receptor
③ AC IN
Connect the power cord to supply electric power to
the projector. ( page 20)
④ Air intake port
⑤ Front leg adjuster
To adjust the projection angle. ( page 24)
NOTE:
•
Do not connect any power cable other than the attached one.
•
Do not cover the ventilation openings of the air intake port or air outlet port.
Terminals
① Connect to a network cable.
(See "Network Operation Manual".)
② Connect to a computer to control the projector's
operation.
( page 19, 53)
③ Connect to a computer or YP
( page 19)
④ Connect to an S-VIDEO signal cable.
( page 18)
NOTE:
•
Do not place your hands or other objects close to the air outlet port as this may cause damage or injury.
•
Do not place your hands or face, or objects which cannot withstand heat near the air outlet port. Hot air comes out
from this port.
14 ENGLISH
②
④
①
②
③
COMPUTER 1 IN
SERIAL
LAN
COMPUTER 2 IN
P
signal cable.
B
R
⑤
⑥
⑦
⑥ Rear leg adjuster
To adjust the projection angle. ( page 24)
⑦ Burglar hook port
Attach a commercial burglar prevention cable.
⑧ Air outlet port
Hot air comes out from this opening.
⑨ Speaker
⑩ Lamp unit compartment ( page 48)
④
S-VIDEO
AUDIO
IN
OUT
⑦
⑥
1
2
VIDEO IN
AUDIO IN
⑤
⑤ Connect to a VIDEO signal cable.
( page 18)
⑥ Connect audio cables for inputting audio signal.
( page 19)
⑦ Connect an audio cable for audio signal output
to the connected equipment. If it is connected to
this terminal, no sound comes out of the built-in
speaker.
( page 18, 19)
⑩
⑨
⑧