UPO PESUKARHU 6012 User Manual page 66

Failure
FAILURE 1
Program temperature not
reached (the machine
reports a failure - the
LEDs periodically fl ash
once)
FAILURE 4
Spinning rpm not reached
in the selected program
(the machine reports
a failure - the LEDs
periodically fl ash four
times)
(in some models,
FAILURE 2 is displayed)
FAILURE 5
Motor operation
interrupted; or motor does
not operate (the machine
reports a failure - the
LEDs periodically fl ash
fi ve times)
FAILURE 6
Program temperature not
reached (the machine
reports a failure - the
LEDs periodically fl ash six
times)
* UKS: universal stability control - this function prevents excessive vibrations during spinning.
66
Possible cause
Temperature sensor
disconnected from the electronic
circuit.
• rpm sensor disconnected
• Motor overload due to too high
water level (manual addition of
water) or too big laundry load
• Motor failure
Motor overload or motor failure.
• Heater failure
• Inlet water too cold
• Manual addition of water
In case you were not successful in repairing the malfunctions in
spite of the above suggestion chart, call the nearest authorized
service shop.
Repairing the failure arising from inappropriate connections or
use of the appliance is not covered by the guarantee, and the
repair expenses are paid by the customer.
Remedy
• Turn off the appliance and wait for
a few seconds;
• turn the appliance back on and
repeat the washing program.
If the failure is reported again, call a
service technician.
• Turn off the appliance and wait for
a few seconds;
• turn the appliance back on and
repeat the washing program.
If the failure is reported again, call a
service technician.
• Turn off the appliance and wait for
a few seconds;
• turn the appliance back on and
repeat the washing program.
If the failure is reported again, call a
service technician.
• Turn off the appliance and wait for
a few seconds;
• turn the appliance back on and
repeat the washing program.
If the failure is reported again, call a
service technician.