Failures - UPO PESUKARHU 6012 User Manual

Failures

The washing machine automatically monitors the execution of particular functions during the
operation, and reports any detected failures.
In such cases signal LED's start fl ashing in certain sequence.
The fl ashing sequence changes in accordance with the nature of the detected failure.
In some cases you may attempt removing certain failures yourself, so count the number of fl ashes,
repeating after certain pauses.
The machine signals failures immediately after detecting them and stops the program, except for
heater failure, where the machine completes the washing program without heating water.
Failures:
2 - Two fl ashes: door is not correctly closed
3 - Three fl ashes: inappropriate water intake
7 - Seven fl ashes: inappropriate water outlet.
In these cases, you will be able to remedy the failure by yourself (See Troubleshooting table).
1 - One fl ash: temperature sensor failure
4 - Four fl ashes: spinning sensor failure
5 - Five fl ashes: motor failure
6 - Six fl ashes: Heater failure
In these cases, turn off the machine, then turn it back on and repeat the program. If the failure
reoccurs, contact your nearest authorized service center. The LEDs will continue to fl ash until the
machine is turned off.
• Carefully turn the fi lter insert in anticlockwise direction and let
the water slowly drain; then remove the fi lter and clean it under
running water.
• Insert the fi lter back as shown on the picture, and tighten by
turning it in clockwise direction. To ensure good sealing the
gasket surface (A) must be dirt free.
63