Still Mode; Signal Mode - Panasonic PT-LM2E Operating Instructions Manual

STILL MODE

S T I L L M O D E
To reduce flickering of still images (vertical
flicker), set "STILL MODE" to "ON".
NOTE:
B Do not set "STILL MODE" to "ON"
when playing back moving images.

SIGNAL MODE

(RGB/YP P only)
B R
This displays the type of signal which is
currently being projected.
Refer to the table on page 58 for details on
each type of signal.
Projecting sRGB-compatible
pictures
sRGB is an international colour reproduction
standard (IEC61966-2-1) established by the
International Electrotechnical Commission
(IEC). If you would like the colours in sRGB-
compatible pictures to be reproduced more
faithfully, make the following settings.
# # Press the F F or G G button to select
"PICTURE MODE", and then press the
I I or H H button to select "NATURAL".
$ $ Press the STD (standard) button on the
remote control unit.
% % Press the F F or G G button to select
"COLOR TEMP.", and then press the I I
or H H button to select "STANDARD".
NOTE:
B sRGB is only enabled when RGB
signals are being input (when "LAMP
POWER" is set to "HIGH").
O F F
[
O N
E -37
NGLISH