General Information And Notes; Preparation - Biketronics BT4180.14 Installation Manual

General Information and Notes

Speaker use – Use a 2 or 4 ohm speaker. For a parallel set-up use 4 ohm.
Care – The amp enclosure is water resistant using a special baffle system to
prevent water from entering the custom enclosure. However, please exercise
good judgement when locating the amp to minimize exposure to any potential
source of water.
Do not modify – Modifications made to the amplifier with void the warranty.
Please call Biketronics if you are not sure about installation.

Preparation

• Remove outer fairing (Remove fairing bolts and disconnect headlight wire
connector).
• Remove seat to access the battery.
DISCONNECT BATTERY
Failure to disconnect the battery will cause a short to ground and is not
covered under warranty.
6