Step 5 Rca Connectors - Biketronics BT4180.14 Installation Manual

Step 5
• Connect RCA connectors to amplifier.
• Installation requires use of transformer between stock speaker wires (high-
level) and amplifier's input RCA connectors (low-level).
• Connect stock front speaker wires to grey and white wires on transformer.
• Use included heatshrink to secure and insulate connections.
• Connect amp's front RCA plugs to RCA jacks found on transformer. Since
some stock radios do not have balance control, RCA polarity may not
matter.
Depending on bike configuration, the rear speaker signal will be connected to
the rear transformer one of three ways:
Ultra Classic
® – custom harness bringing signal from rear pod area.
Road Glide and Street Glide
®
Custom Setup – spliced into rear speaker wiring.
RCA Connectors
Rear Amp Input
– using the rear speaker connector in fairing.
®
11