Advertisement
SAFETY PRECAUTIONS
When using any electrical appliance, basic safety precautions should always be followed,
including the following:
1. Read all instructions and keep for future reference.
2. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge. Unless
they are under supervision or given instructions concerning the use of the appliance by a
person responsible for their safety.
3. Young children should be supervised to ensure that they do not play with the appliance.
4. Always unplug the appliance from the socket when not in use.
5. To disconnect the appliance, switch the control to OFF, then unplug from the socket.
6. To unplug the appliance, always grasp the plug; do not pull the cord.
7. If the supply cord is damaged it must be replaced by the manufacturer, it's service agent
or a similarly qualified person in order to avoid any hazard.
8. Do not use outdoors. This appliance is designed for household use only.
9. Keep the power cable away from areas where people walk so that it cannot be stepped on
or tripped over.
10. Always use the appliance on a flat, stable surface.
11. Never clean this appliance when it is plugged in .Do not immerse it in water, clean the
outside surface with a damp cloth or soft brush and dry with a soft dry cloth.
12. Use the appliance only as directed in this manual. Misuse could void your warranty.
13. Avoid contact with moving parts, never insert any objects through the grill when the fan is
in operation.
ASSEMBLY INSTRUCTIONS:
Body Assemble
1. Unscrew the Ring and Base Locking Screw from the Pipe.
2. Insert the Pipe through the hole in the center of the Base
and twist into position.
3. Tighten the Base by Ring and Base Locking Screw.
4. Unscrew the Locking Nut from the Fan Head.
5. Put the Fan Head into the Pipe and use the
Screw to tighten the Fan Head and the Pipe
Fan Grill Assemble
1. Turn the Screw clockwise to tighten Rear Grill and the Motor firmly.
2. Install the Blade onto the Motor Shaft by tightening the blade screw.
3. Centre the Front Grill by aligning the logo on the grill Hub so it is horizontal and parallel to
the floor. Then secure the Front and Rear Grills completely together by snapping grill clips
into place. Lastly, tighten the grill locking screw at the bottom of the Rear Grill.
Advertisement
