Plumbing - Miele G 7882 Operating Instructions Manual

Connection to the water inlet
,
Water in the machine is not suit-
able for drinking.
^ The machine must be connected to
the water supply in accordance with
local and national regulations (WRC
the U.K.).
^ The machine is constructed to com-
ply with German gas and water regu-
lations (DVGW) and may be con-
nected to a suitable supply without
an extra non-return valve if national
regulations allow this.
^ The water pressure (flow rate) must
be a minimum of 0.5 bar (50 kPa).
If the water pressure (flow rate) is be-
low 2 bar (200 kPa) the fill time is au-
tomatically extended.
The max. permitted static pressure is
10 bar (1000 kPa).
If the water pressure is not in the
range of 0.5 to 10 bar (50-1000 kPa)
the p / 6 indicator light may come
on and the fault code "F..E" show in
the display. Contact the Miele Service
Department for advice.
^ For technical application reasons the
machine is supplied as standard for
connection to cold water only.
The inlet hoses (water inlet and
steam condenser) must only be con-
nected to the cold water stopcocks.
See next page for the AD water con-
nection (hose marked H
^ Stopcocks with 3/4 BSP male thread
^ The DN 10 inlet hose is approx. 1.7 m
^ Large surface area filters are en-
O pur).
2
See also the installation diagram sup-
plied.
are to be provided on site. They
should be easily accessible so that
the water supply can be turned off
when the machine is not in use.
long terminating in a 3/4 inch female
thread. On no account must the inlet
filters be removed.
closed in the kit supplied with the
machine for installing between the
stopcock and the inlet hose
(see illustration in "Cleaning and Care
Water inlet").
The large surface area filter for AD
water is made from chrome nickel
steel and can be recognised by the
matt top surface.
,
The inlet hose must not be short-
ened or damaged in any way (see il-
lustration).

Plumbing

57