Power Off Timer; Direct Power On; Control Panel; Auto Setup - Panasonic PT-F200U Operating Instructions Manual

POWER OFF TIMER

You can set the off timer to switch off the POWER of the
projector after a certain period of time automatically
when no signal is detected. Press I H to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
DISABLE
15 MIN.
20 MIN.
25 MIN.
30 MIN.
35 MIN.

DIRECT POWER ON

You can switch the projector start up status for when the
Mains lead is connected while the MAIN POWER is on,
or for when the MAIN POWER is switched on while the
Mains lead is connected. Press I H to select the
required option.
OFF The projector will start from the
standby mode or the projecting
mode.
ON The projector will start from the
projecting mode.
NOTE:
• When the projector is started from the projecting mode,
pressing the POWER button procedure is skippable.

CONTROL PANEL

You can turn off the function of the control panel buttons
on the projector body. Press I H to select the required
option.
INVALID Invalidate the control panel buttons
Confirmation screen will be
displayed.
VALID Validate the control panel buttons

AUTO SETUP

You can turn off the AUTO SETUP function for when the
COMPUTER signal is detected.
60 MIN.
55 MIN.
NOTE:
50 MIN.
45 MIN.

SIGNAL SEARCH

40 MIN.
You can turn off the auto signal detecting system.
NOTE:

INSTALLATION

When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See "Projection method" on
page 15.

ALTITUDE

If you use the projector at high elevation, the ALTITUDE
setting need to be HIGH to set the fan speed high. Press
I H to select the required option.
NOTE:
AUTO When the projector detect a
COMPUTER signal, adjust the
projected image position
automatically for SIGNAL SEARCH,
DOT CLOCK and CLOCK PHASE.
BUTTON Only when the AUTO SETUP button
is pressed, the projected image
position will be adjusted for DOT
CLOCK and CLOCK PHASE. See
"Remote control" on page 11.
• Usually the recommended setting is AUTO.
ON Detect the input signal from the
terminals and project the image.
OFF Deactive
• SIGNAL SEARCH is not available when any input
signal is projecting.
• Usually the recommended setting is ON.
Setting on a desk/floor and
FRONT/DESK
projecting from front
Mounting in the ceiling and
FRONT/CEILING
projecting from front
Setting on a desk/floor and
REAR/DESK
projecting from rear
Mounting in the ceiling and
REAR/CEILING
projecting from rear
LOW The fan speed is low.
HIGH The fan speed is high.
• At 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, the
setting must be HIGH.
• The loudness of fan noise depends on the ALTITUDE
setting.
OPTION menu
E
NGLISH - 35