Panasonic PT-F200U Operating Instructions Manual page 13

Back and bottom view
Security lock
Attache the commercial shackle
lock, manufactured by Kensington,
to protect your projector.
Compatible with the Kensington
MicroSaver Security System.
ARF (Auto Rolling Filter)
compartment
(page 40)
LAN
Connect a LAN cable for network
connection. This terminal is
PT-F200NTU only
SERIAL
See "Serial terminal" on page 45.
REMOTE
See "REMOTE terminal" on
page 47.
NOTE:
• Do not cover the ventilation openings or place anything within 50 cm (20") of them as this may cause damage or injury.
• When a cable is connected to the VARIABLE AUDIO OUT, the built-in speaker will be disabled.
Font leg adjusters
Screw up/down to adjust the
projection angle. (page 15)
COMPUTER1 IN
Connect an RGB signal cable from
a computer.
COMPUTER2 IN/1 OUT
Connect an RGB signal cable from
Selectable for input
a computer.
and output by menu operation.
COMPUTER AUDIO IN
Connect audio cables for inputting
audio signals corresponding to
COMPUTER1 IN and/or
COMPUTER2 IN/1 OUT.
About Your Projector
Lamp unit compartment
(page 41)
Air exhaust port
Heated air comes out of this
opening.
MAIN POWER
Switch the projector on/off.
(page 21)
Burglar hook port
Attach a commercial burglar
prevention cable.
AC IN
Connect the Mains lead to supply
electronic power to the projector.
(page 20)
S-VIDEO IN
Connect a S-VIDEO signal cable.
VIDEO IN
Connect an RCA composite video
cable.
AUDIO IN
Connect audio cables for inputting
audio signal corresponding to
VIDEO IN, S-VIDEO IN and
COMPONENT IN.
COMPONENT IN
Connect a YP P signal cable.
B R
VARIABLE AUDIO OUT
Connect an audio cables for
outputting audio signals to the
connected equipment.
E
NGLISH - 13