Troubleshooting Guide; Specifications - LEXIBOOK MICRO STAR 2 K8010 Instruction Manual

Standby Mode
After this product remains inactive for more than 15 minutes, the unit will switch to the standby
mode (the LCD display will switch off and the red LED will switch on).
Please press the "VOICE" button to resume working. The red LED will then switch off and the
LCD screen will resume working, showing the last information displayed.
SYMPTOM
Squealing through
the speakers
No sound from
speakers
I can't hear myself
singing
No sound from
multimedia player
General
Power supply...................................................................... AC 230V ~ 50Hz
Power consumption............................................................ 25W
Speaker ............................................................................. 8 Ohms
Output power...................................................................... 2 x 8W RMS
Dimensions......................................................................... 13 (W) x 48 (H) inches
Specifications are subject to change without notice.

TROUBLESHOOTING GUIDE

CAUSE
Microphone
feedback.
Master volume
control is set to
minimum.
Power is off.
Standby mode
is on
Microphone is not
plugged in.
Volume is too low.
Cable is not
connected
correctly.

SPECIFICATIONS

SOLUTION
Keep the microphone as far away from the
speakers as the microphone cable allows or
reduce the volume until the noise stops. If
using a commercial CD or MP3, make sure
the balance control is set to the centre position
so you can hear both vocal and music tracks
equally.
Use the master volume control + to increase
the overall volume.
Turn power button on and LCD display will
switch on.
Press the "VOICE" button to resume working.
Plug microphone into Mic 1 or Mic 2 jack.
Turn Mic 1 or Mic 2 volume control up.
Check the Line-in cable is connected from the
multimedia player's line-out jack to the Media-in
jack.
29