Setting Menu - Acer lcd monitor series User Manual

Setting Menu

The Setting menu is used for adjusting the general settings for current input signal such
as aspect ratio, OSD language, and etc.
Setting
Wide Mode
DDC/CI
OD
ACM
Input
DP Format
DTS
Language
1 Press the Menu button to bring up the OSD menu.
< >
2 Press the / button to select
Setting menu.
The following options are available in the Setting menu: Wide Mode, DDC/CI, OD,
ACM, Input, DP Format, DTS, Language, Auto Source, Quick Start mode, and Reset.
< >
3 Press the / button to scroll through the Setting options, and press the Menu
button to enter its sub-menu.
< >
4 Press the / button to adjust/select the setting and press the Auto button to
confirm.
5 Wide mode: You can select which screen aspect you are using. The options are Full,
Aspect, and 1:1.
6 DDC/CI: Allows the monitor settings to be set through the software on the PC.
Note: DDC/CI, short for Display Data Channel/Command Interface,
which allows monitor controls to be sent via software.
7 OD: Select Off, Normal, or Extreme.
8 ACM: Turn ACM on or off. The default is off.
9 Input: Select the source from DVI, HDMI, DP, or miniDP.
10 DP Format :Default is DP1.2, can selection DP support DP1.1 or DP1.2 format.
11 DTS: Turn DTS Sound On or Off. Your monitor is equipped with two 3W speakers on
the rear. DTS Sound is stratified and creates a remarkable sonic flow.
12 Language: Set the OSD menu language.
13 Auto Source:The default is "On", can support auto search for signal source in order.
14 Quick start mode: Select Off or On. The default is "Off". Turn on to speed up boot
speed.
15 Refresh rate num: Display the panel's current refresh rate on the screen. The default
value is "Off".
Full
ON
Normal
OFF
HDMI
DP12
OFF
English
Setting and press the Menu button to enter the
Setting
Auto Source ON
Quick Start mode ON
Refresh Rate Num
OFF
Reset
13