Level Sensor
Detect the horizontality of the camera.
Horizontal and vertical bar represent two directions parallel to sea level. Set the center of the horizontal bar and the center of
vertical bar as base points. There are 15 sections on both up and down side from the base point for the vertical bar and 15 sections
on both left and right side from the base point for the horizontal bar. Each section represents inclination of 1°. When the tilt angle is
more than 50°, the axial directions corresponding to the horizontal bar and vertical bar will change.
+Z
-Y
-X
+Y
-Z
+X
EV settings
Adjust the brightness of framing interface. It is applied to the circumstance where the contrast of shot subject and background
brightness is relatively large.
EV value can be adjusted through sliding a finger up and down.
+Y
+Z
-X
-Y
-Z
-Z
-Y
+X
01:27:26
-X
+Z
+X
+Y
5°
+0.7
+0.3
0.0
5°
0°
5°
0°
5°
16