Kenwood KDC-1032 Service Manual page 10

KDC-1032/132/132CR
KDC-133/233/234SGY
[6] key • Press the key for less than a second: PANEL open/
close count display.
• Press the key for more than 2 seconds while the
PANEL open/close count is displayed: PANEL open/
close count is cleared.
(Display) PnL_x
[FM] key • ROM correction version display.
(Display)
When valid: RKKK (K: numeric)
When invalid (when unreadable): R– – –
When invalid (when the version is different): Rooo
[AM] key • IC10 adjustment status.
(Display)
Adjustment complete: E2OK
Unadjusted: E2ER
Communication error: ICER
∗ Set Pin 19 to "H" output for E2P OK.
[TRACK- • Mechanism error detection status.
• Communication error → Error No. 1 → Error No. 2 →
DOWN]
Error No. 3 → Communication error
key
(Error No. 1 is the latest)
• The detection status is cleared by pressing [TRACK-
DOWN] key for more than 2 seconds during status
display.
(Display)
When communication OK: ICOK
Communication error: ICER
Not detected: En – – (n: 1~3)
When detected: En∗∗ (∗∗: error code)
[TRACK- • AUDIO data initial value setting
UP] key (Display) INIT
Backup current measurement
The MUTE terminal turns off in 2 seconds instead of 15
seconds when moved to ACC OFF.
LCD short check
Switching the process in the following order by pressing [ATT]
key in the STANDBY source.
1. All indicators turn off.
2. Turn on odd terminals and even terminals of the largest
group of segments in every 250m sec.
10
TEST MODE
XXXX MAX 60000 (time)
3. Turn on only odd terminals.
4. Turn on only even terminals.
5. All indicators turn on.
(∗ Return to the first to repeat.)
Others
• When you start up the system in test mode, change the
LINE MUTE inhibition time to 1 second from 10 seconds.
Clearing CD mechanism error information
(E2PROM data clear)
Press [ATT] + [Q] keys to reset (Reset is the only way to
cancel information).
• Memory clear mode display
Display: MCLR
• Memory clear status display (The result of clearing will be
displayed in 2 seconds after startup).
Display
Normal termination: CD_O
Abnormal termination: CD_–
FM/AM channel space switching
(only K or M destination models)
Press [1] + [5] keys and [SRC] key simultaneously during
ACC ON/Power OFF.
IC10 (X34-) stereo adjustment (VCO adjustment)
Press [1] key and [6] key simultaneously while all indicators
are on (STANDBY) in test mode.
(Adjusted data will be written on E2PROM)
Setting for OEM destination
Use pin 2 on the system µ-com terminal to support OEM
model.
TUN TYPE1 TUN TYPE2
(Pin 5) (Pin 6)
q KENWOOD brand model
Low Low
w KENWOOD brand model with
High Low
e OEM model with CRSC changed
Low High
r OEM model with CRSC &
High High
Description
CRSC changed
De-emphasis changed