General Operation; How To Select The Indoor Or Outdoor Temperature Reading; How To Reset The Maximum Or Minimum Memories - Oregon Scientific NTS-912 User Manual

GENERAL OPERATION

The unit has two operating modes: MAX/MIN DISPLAY
MODE and HI/LO DISPLAY MODE. To change from one
mode to another, press [MODE] button once.
MAX/MIN DISPLAY MODE:
Shows the current temperature and the maximum and
minimum temperature at the same time.
NOTE Initially the 'Max' and 'Min' values will display the
same temperature values as the current temperature display
until changes in temperature are recorded.
HI/LO DISPLAY MODE:
Shows the current temperature and the preset high and low
temperature alarm limit.
HOW TO SELECT THE INDOOR OR OUTDOOR
TEMPERATURE READING
The outdoor temperature will be measured if the outdoor
sensor probe is plugged in, and indoor temperature is
measured if the outdoor sensor probe is removed.
The outdoor sensor plug is located inside the battery
compartment.
To remove/plug in the outdoor sensor, slide the battery cover
in the direction of the arrow, then remove/insert the plug
toward/away from the battery.
4
NTS912manual-E
TO SELECT OUTDOOR TO SELECT INDOOR
TEMPERATURE TEMPERATURE
(PLUG IN THE SENSOR)
(REMOVE THE SENSOR)
HOW TO RESET THE MAXIMUM OR MINIMUM
MEMORIES
There are two ways to reset the Max / Min memories,
1. For resetting both memories – In the MAX/MIN DISPLAY
MODE, press the [MEMORY CLEAR] button once.
2. For resetting individual Max or Min memories – In the
MAX/MIN DISPLAY MODE, press either the [MAX] button
or the [MIN] button once to reset the respective memory.
The other memory will be unaffected.
NOTE Resetting a memory will result in current temperature
being displayed in the Max or Min memory display.
4
04/12/15, 5:39 PM