Connection; Setup Precautions - Panasonic PT PT-DW5100EL Operating Instructions Manual

Connection

Setup precautions

• Before connecting any of your video/audio equipment to the projector, carefully read the owners manual
supplied with the equipment once again.
• All cable connections should be made with the entire system devices, including the projector, first turned off.
• Obtain commercial interconnecting cables for devices supplied with no accessory or optional interconnect
cables.
• Video signals containing too much jitter may cause the images on the screen to randomly wobble or shake.
Inserting a time base corrector (TBC) in the projector's video line will relieve this problem.
• The projector only accepts composite-video, S-Video, analogue-RGB (with TTL sync. level) and digital signal.
• Some PC models are not compatible with PT-D5700E/PT-D5700EL/PT-DW5100E/PT-DW5100EL projectors.
• When using long cables to connect various equipment to the projector, there is a possibility that the image will
not be output correctly unless a compensator is used.
• The pin assignments on the S-VIDEO IN terminal are
as follows:
Viewed from mating side
• The pin assignments on the RGB2 input terminal are
as follows:
Viewed from mating side
Pin : Not used.
Pins - , and
20
Pin No. Signal
Ground (luminance)
Ground (colour)
Luminance signal
Colour signal
Pin No. Signal
R/P
R
G/G · SYNC/Y
B/P
B
HD/SYNC
VD
: Ground
• The pin assignments on the DVI-D input terminal
are as follows (interface with DVI-D output
terminal on PC):
Viewed from mating side
Pin No. Signal
T. M. D. S data 2–
T. M. D. S data 2+
T. M. D. S data 2
shield
DDC clock
DDC data
T. M. D. S data 1–
T. M. D. S data 1+
T. M. D. S data 1
shield
• The DVI-D input terminal supports single link only.
• EDID settings may be needed depending on the DVI
equipment being connected. (page 35)
• The DVI-D input terminal can be used to connect to a
DVI equipment, but note that images may not appear
or the projector may not work properly when
connected to certain DVI equipment.
• This projector supports HDCP.
.
Pin No Signal
+5 V
Ground
Hot plug sense
T. M. D. S data 0–
T. M. D. S data 0+
T. M. D. S data 0
shield
T. M. D. S clock
shield
T. M. D. S clock+
T. M. D. S clock–