Panasonic TX-47P950A Operating Instructions Manual page 25

C. TEMP (Colour Temperature)
Set the overall colour tone of the picture.
Press to switch between modes.
D.PNR (Digital Picture Noise Reduction)
Automatically reduces undesired picture noise.
Press to switch between modes.
Reduces noise in a channel with many noises.
Remains off when receiving a strong signal.
Off:Recommended mode when receiving a strong signal.
Strong:Applies strong noise reductions regardless of input signals.
Weak:Applies weak noise reductions regardless of input signals.
Auto:Automatically reduces unwanted picture noise.
SCAN MODE
When receiving PAL or SECAM Signal, SCAN MODE is
displayed.
Choose the screen refresh method:
Press to switch between modes.
Note:
When viewing a PAL transmission (other than PAL 60) with Scan mode set to Progressive, the screen
will flicker, this is not a fault.
Helpful Hint (
By pressing the Normal "N" Button on the Remote Control while the Picture menu is displayed, the selected menu will be changed
to the Normal Mode.
Normalization will not occur if the menu is not displayed when the "N" Button is pressed.
The Normal mode is the factory preset condition. Returning to this original condition is called "Normalization".
STANDARD WARM
STRONG
OFF
AUTO WEAK
100 Hz MODE
MODE
100Hz MODE 100Hz will give a steady picture for most signal transmission.
PROGRESSIVE Avoids "snaking/jaggy" effect when viewing TV program with
moving characters.
N Normalization)
COOL
PROGRESSIVE
Function
Picture Adjustment
PICTURE
MENU DYNAMIC
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
STANDARD
C. TEMP
D. PNR AUTO
SCAN MODE
100Hz
PICTURE
MENU DYNAMIC
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP STANDARD
D. PNR AUTO
SCAN MODE 100Hz
PICTURE
MENU DYNAMIC
CONTRAST
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP STANDARD
D. PNR
AUTO
100Hz
SCAN MODE 100Hz
When receiving PAL or
SECAM Signal
25