Panasonic TX-47P950A Operating Instructions Manual page 11

Power (Stand-by) (see page 6)
The TV set must first be plugged into the wall out-
let and turned on at the power switch.
Press this button to turn the TV set On from Standby
mode, press it again to turn the TV set OFF to
Standby mode.
5
VCR DVD
REC
TV
Note:
• It is also possible to turn the TV set on from STANDBY
mode by pressing the "Direct Programme Number Se-
lection" Buttons (0-9) and the "Programme Number Up
or Down" Button, either on the set or on the Remote Con-
trol.
Off timer (see page 23)
Multi Screen (see page 29)
Aspect (see page 28)
Surround (see page 26, 27)
Normalization (see page 25, 27)
Programme Number Selection
Press to select the next higher
or lower Programme number.
Press to store settings in Tuning
menu.
TEXT hold (see page 32)
/Still (see page 29)
TEXT Index (see page 33)
/Channel Search (see page 30)
VCR/DVD CONTROL
(see page 34)
General Operation
TV/AV Mode Selection
Press to select TV, AV1, AV2, AV3 and
AV4 input signal modes sequentially.
Remote control :
TV/AV
AV1 AV2 AV3
Press to display AV1 - AV4 at the bot-
tom of the screen. Each coloured but-
ton corresponds to each input signals.
For example, pressing the Red button
selects AV1.
Direct programme Number
• Direct Programme Number Selection
You can select the number directly by
pressing the corresponding programme
number buttons.
Programme Number 8......
Programme Number 36....
Programme Number 124...
Note:
• When the Skip setting for Programme
Number 100 through 125 is on, the
channel selection time will be short-
ened, and thus you can not input
three digits at a time.
AV4
8
3 6
1 2 4
11