Automatic Tune - Panasonic TX-47P500H Operating Instructions Manual

Wide projection television
Table of Contents

Advertisement

Tuning Channels

Automatic Tune

This TV uses automatic tuning to determine whether or not the TV can receive a broadcast signal which is being sent, and
automatically prepares so that the channel selection can respond to both the position select and direct select modes.
Before Automatic Tune, Channel Select and Regional System must already be set (Refer to pages 19).
1
AUTO TUNE
2
SOUND SYS
STR
TV/AV
Note:
When the sound volume is too small to confirm, turn it up by using the sound volume button on the remote control.
3
Helpful Hint
(1) If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the
"Colour System Selection" operation on page 21.
(2)
After the Automatic tune is finished, under the normal viewing condition press this button to
confirm the tuning condition for each Programme Number. If some Programme Numbers are
unused (no TV stations), it is possible to skip such Programme Numbers. Please refer to the
Programme Number Skip operation on page 27.
24
Press to select the "AUTO TUNE".
Press to access to the "AUTO TUNE".
Search Start.
29
CH 29
AUTO SETUP IN PROGRESS
SEARCHING : PLESE WAIT
STORED CH29
SETUP : RETURN TO TUNING MENU
TV/AV : TO EXIT
After all stations are tuned, the on-screen display will automatically change from "AUTO
TUNE" to "SOUND SYS" Position.
Press to improve the Sound quality, if the Sound
is not clear or no sound is produced on a
programme Number Position.
4.5MHz
5.5MHz
6.5MHz
6.0MHz
Press to store the Sound System.
Press to exit from the Tuning Menu.
This returns the set to the normal viewing condition.
Under the normal viewing condition press to enter each programme Number.
Confirm the tuning condition.
If necessary, repeat step 2 for each Programme Number.
TUNING MENU
CH SELECT
SYS SELECT
AUTO TUNE
MANUAL TUNE
SOUND SYS
COLOUR SYS
FINE TUNE
SKIP
When a station is found.
The best tuning position is automatically
memorized.
TUNING MENU
CH SELECT
SYS SELECT
AUTO TUNE
MANUAL TUNE
SOUND SYS
COLOUR SYS
FINE TUNE
SKIP
POSITION
JAPAN
ACCESS
6. 0MHz
AUTO
OFF
POSITION
JAPAN
6. 0MHz
AUTO
OFF

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tx-47p500x

Table of Contents