Automatic Tune - Panasonic TX-43P800H Operating Instructions Manual

Tuning Channels

Automatic Tune

This TV uses automatic tuning to determine whether or not the TV can receive a broadcast signal which is being sent, and
automatically prepares so that the channel selection can respond to both the position select and direct select modes.
Before Automatic Tune, Channel Select and Regional System must already be set (Refer to pages 16).
1
AUTO TUNE
Press to select the "AUTO TUNE".
Press to access to the "AUTO TUNE".
2
After all stations are tuned, the on-screen display will automatically change from "AUTO TUNE"
SOUND SYS
to "SOUND SYS" Position.
Press to improve the Sound quality, if the Sound is not clear or no
sound is produced on a programme Number Position.
STR
Press to store the Sound System.
TV/AV
Press to exit from the Tuning Menu.
This returns the set to the normal viewing condition.
Note:
When the sound volume is too small to confirm, turn it up by using the sound volume button on the remote control.
3
Under the normal viewing condition press to enter each programme Number.
Confirm the tuning condition.
If necessary, repeat step 2 for each Programme Number.
18
Search Start.
29
CH 29
AUTO SETUP IN PROGRESS
SEARCHING : PLESE WAIT
STORED CH29
SETUP : RETURN TO TUNING MENU
TV/AV : TO EXIT
4.5MHz 5.5MHz
6.5MHz 6.0MHz
When a station is found.
The best tuning position is automatically memorized.
CH SELECT POSITION
SYS SELECT ASIA / M.EAST
AUTO TUNE ACCESS
MANUAL TUNE
SOUND SYS 5. 5 MHz
COLOUR SYS AUTO
FINE TUNE
SKIP OFF
CH SELECT POSITION
SYS SELECT ASIA / M.EAST
AUTO TUNE
MANUAL TUNE
SOUND SYS 5. 5 MHz
COLOUR SYS AUTO
FINE TUNE
SKIP OFF