Generator - Predator 2000 Owner's Manual & Safety Instructions

Connecting 120VAC Loads to the Generator
Calculate power Draw:
Power draw can be calculated by multiplying volts and amps. The resulting number is wattage.
• Never exceed the running wattage for the Generator or any outlet amperage rating.
• Refer to appliance/tool owner's manuals to determine the wattage of electrical load devices.
• Long power cords and extension cords draw additional power. Keep cord length at a minimum.
Wattage Estimates
Wattages listed below are estimates for that type of equipment only.
Check nameplate wattages on all loads before connecting to Generator.
This Unit Can power Any
One of the Following Items:
1/4 HP Air Compressor
1/6 HP Motor
3/8" Drill
Mini Refrigerator
Table/Box Fan
15 Amp Battery Charger
String Trimmer
Hedge Trimmer
Radio
Ten 75 Watt Light Bulbs
Overload Light
Note: The OVERLOAD light may turn on for a few seconds as a large device starts up.
This is normal for loads approaching the capacity of this Generator.
1. The total combined load through the
outlet on the Generator must not exceed
the running power of the unit.
2. If the OVERLOAD light turns on and the Generator
stops producing power, it has been overloaded.
3. Disconnect all electrical devices, and
compare device requirements to Generator rating.
Move anything that may be limiting
Generator ventilation away.
4. Press and hold Overload Reset button
above the Dual 120VAC Receptacle
until OVERLOAD light turns off.
5. Reconnect devices while being careful
to not overload Generator.
Economy (ESC) Switch
1. Turn the Economy (ESC) Switch ON to limit noise
and fuel consumption for lighter generator loads.
ITEM 62523
Running Start-up
Watts Watts
600 900
500 800
400 600
400 700
200
380
350
500
50
750
For technical questions, please call 1-888-866-5797.
Figure A: plug Load In
Plug the power cord of the 120 volt appliance/tool
into the 120VAC Outlet on the Generator. Plug in
appliances from largest to smallest load.
Note: Do not allow the Generator to completely run
out of fuel with devices attached. A Generator's
output may sharply spike as it runs out of fuel,
causing damage to attached devices.
p U T
O U T
A D
R L O
O V E
O I L
L O W
2. Turn the Economy (ESC) Switch OFF
to operate engine at full speed:
a. when starting,
b. when a heavy load is applied, or
c. when using the 12VDC output.
Overload
Reset
Button
Page 11