Honda 1996 Prelude Owner's Manual page 135

Engine Oil
OIL FILTER
3. Remove the oil filter and let the
remaining oil drain. A special
wrench (available from your
Honda dealer) is required to
remove the filter.
Maintenance
4. Install a new oil filter according to
instructions that come with it.
5. Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten it to:
39 N . m (4.0 kgf . m , 29 lbf . ft)
6. Refill the engine with the recom-
mended oil.
Engine oil change capacity
(including filter):
(U.S.: S, Canada: S)
3.8 l (4.0 US qt,3.3 lmp qt)
(U.S.: Si, Canada: SR)
4.3 l (4.5 US qt, 3.8 Imp qt)
(U.S.: VTEC, Canada: SR-V)
4.8 l (5.1 US qt,4.2,lmp qt)
7. Replace the engine oil fill cap.
Start the engine. The oil pressure
indicator light should go out within
five seconds. If it does not, turn off
the engine and reinspect your
work.
8. Let the engine run for several
minutes and check the drain bolt
and oil filter for leaks.