Yamaha 2008 XVS11AWX Owner's Manual page 25

Right (XVS11AWX)
1. Engine stop switch " / "
2. Hazard switch " "
3. Start switch " "
Pass switch " "
Press this switch to flash the headlight.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
INSTRUMENT AND CONTROL FUNCTIONS
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
EAU12350
Start switch "
Push this switch to crank the engine
EAU12400
with the starter.
CAUTION:
See page 5-1 for starting instruc-
tions prior to starting the engine.
EAU12460
"
". When re-
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12500
" turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
EAU12660
/ "
might be a traffic hazard.
" before starting
" to
CAUTION:
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12710
"
ECA10050
3-7
EAU12733
" (XVS11AWX)
" posi-
3
ECA10061