Exterior Lighting; Combination Switch - Mercedes-Benz 2013 CLA Owner's Manual

Headlamp range control
Driver's seat and front-passenger seat
g
occupied
Driver's seat, front-passenger seat and
1
rear seats occupied
Driver's seat, front-passenger seat and
2
rear seats occupied, luggage compart-
ment laden
Driver's and front-passenger seats occu-
3
pied and maximum permissible rear axle
load utilised, e.g. when towing a trailer
X
Start the engine.
X
Turn the headlamp range control to the
position which corresponds to the load in
your vehicle.

Combination switch

Turn signals
Main-beam headlamps
:
Turn signal, right
;
Headlamp flasher
=
Turn signal, left
?
X
To indicate briefly: press the combination
switch briefly to the pressure point in the
direction of arrow ; or ?.
The corresponding turn signal flashes three
times.
X
To indicate: press the combination switch
beyond the pressure point in the direction
of arrow ; or ?.
Main-beam headlamps
X
To switch on the main-beam head-
lamps: turn the key in the ignition lock to
position 2 or start the engine.
X
Turn the light switch to L or Ã.
X
Press the combination switch beyond the
pressure point in the direction of
arrow :.
In the à position, the main-beam head-
lamps are only switched on when it is dark
and the engine is running.
The blue K indicator lamp in the instru-
ment cluster lights up when the main-beam
headlamps are switched on.
X
To switch off the main-beam head-
lamps: move the combination switch back
to its normal position.
The blue K indicator lamp in the instru-
ment cluster goes out.
i
Vehicles with Adaptive Highbeam Assist:
when Adaptive Highbeam Assist is active,
it controls activation of the main-beam
headlamps ( Y page 111).
Headlamp flasher
X
To switch on: turn the key in the ignition
lock to position 1 or 2, or start the engine.
X
Pull the combination switch in the direction
of arrow =.

Exterior lighting

Z
109