Ligent Light System - Mercedes-Benz 2013 CLA Owner's Manual

Table of Contents

Advertisement

X
Press the : or 9 button to select the
Daytime driving lights
Daytime driving lights
If the
has been switched on, the cone of light and
the W symbol in the multifunction dis-
play are shown in red.
X
Press the a button to save the setting.
Further information on daytime driving lights
(
Y
page 107).
Switching the Intelligent Light System
on/off
X
Press the = or ; button on the steer-
ing wheel to select the
X
Press the : or 9 button to select the
Light
submenu.
X
Press a to confirm.
X
Press the : or 9 button to select the
Intell. Light System
Intell. Light System
If the
been switched on, the cone of light and the
L symbol in the multifunction display
are shown in red.
X
Press the a button to save the setting.
Intell. Light System
If you activate the
function, you activate the following functions:
Motorway mode
R
Active light function
R
Cornering light function
R
Extended range foglamps
R
If you set the dipped-beam headlamps for
driving on the right/left (
multifunction display shows the
Light System: System inoperative
Inactive for left-side traffic
Intell. Light System: System inoper‐
ative Inactive for right-side traf‐
fic
display message instead of the
Light System:
function in the
menu.
Further information on the Intelligent Light
System (
Y
page 110).
function.
function
Settings
menu.
function.
function has
Y
page 221), the
Intell.
or
Intell.
Light
sub-
Menus and submenus
Setting the dipped-beam headlamps for
driving on the left/right
X
Press the = or ; button on the steer-
ing wheel to select the
X
Press the : or 9 button to select the
Light
submenu.
X
Press a to confirm.
X
Press : or 9 to select the
beams Setting for:
You will see the selected setting:
side traffic
Left-side
or
X
Press the a button to save the setting.
If you change the setting, conversion does
not take place until the next time the vehi-
cle is stationary.
This function is only available on vehicles with
the Intelligent Light System.
You can use this function to switch between
symmetrical and asymmetrical dipped beam
(
Y
page 106).
If you set the dipped-beam headlamps for
driving on the left/right, then motorway
mode and the extended range foglamps are
unavailable.
You can also have the dipped-beam head-
lamps set for driving on the right/left at a
qualified specialist workshop, e.g. a
Mercedes-Benz Service Centre.
Switching Adaptive Highbeam Assist on/
off
X
Press the = or ; button on the steer-
ing wheel to select the
X
Press the : or 9 button to select the
Light
submenu.
X
Press a to confirm.
X
Press the : or 9 button to select the
Adapt. main beam
Adapt. main beam
If the
been switched on, the cone of light and the
_ symbol in the upper multifunction
display are shown in red.
X
Press the a button to save the setting.
Settings
menu.
Dipped
function.
Right-
traffic.
Settings
menu.
function.
function has
Z
221

Advertisement

Table of Contents
loading

Table of Contents