Jump-Starting Procedure - Toyota 1998 Sienna Owner's Manual

JUMP STARTING PROCEDURE
1. If the booster battery is installed in
another vehicle, make sure the vehicles
are not touching. Turn off all unneces-
sary lights and accessories.
2. If required, remove all the vent plugs
from the booster and discharged batter-
ies. Lay a cloth over the open vents
on the batteries. (This helps reduce the
explosion hazard, personal injuries and
burns.)
3. If the engine in the vehicle with the
booster battery is not running, start it
and let it run for a few minutes. During
jump starting, run the engine at about
2000 rpm with the accelerator pedal
lightly depressed.
Discharged
battery
Booster battery
Positive
terminal
("+" mark)
Jumper
Positive terminal
cable
("+" mark)
4. Make the cable connections in the or-
der a, b, c, d.
a. Connect the clamp of the positive
(red) jumper cable to the
( ) terminal on
charged battery.
b. Connect the clamp at the other end
of the positive (red) jumper cable to
the positive ( ) terminal on
the booster battery.
name. SIENNA (U)
Discharged
battery
Negative
terminal ( "–" mark )
c. Connect the clamp of the negative
(black) jumper cable to the negative
( ) terminal on the booster
battery.
positive
the dis- d. Connect the clamp at the other end
of the negative (black) jumper cable to
a solid, stationary, unpainted, metallic
point of the vehicle with the discharged
battery.
The recommended connecting point is
shown in the following illustration:
Jumper cable
Booster
battery
191