Removing A Wheel - Mercedes-Benz 2013 C-Class Coupe Owner's Manual

X
Using wheel wrench :, loosen the bolts on
the wheel you wish to change by about one
full turn. Do not unscrew the bolts com-
pletely.
The jacking points are located just behind the
front wheel arches and just in front of the rear
wheel arches (arrows).
X
Position jack = at jacking point ;.
X
Make sure that the base of the jack is posi-
tioned vertically under the jacking point.
X
Turn crank ? clockwise until jack = sits
completely on jacking point ; and the
base of the jack lies evenly on the ground.
X
Turn crank ? until the tyre is raised a max-
imum of 3 cm off the ground.

Removing a wheel

! Do not place wheel bolts in sand or dirt.
The threads of the wheel bolts and wheel
hubs could otherwise be damaged when
the bolts are tightened.
X
Unscrew the wheel bolts.
X
Remove the wheel.
Fitting a new wheel
G
WARNING
Oiled or greased wheel bolts or damaged
wheel bolts/hub threads can cause the wheel
bolts to come loose. As a result, you could
lose a wheel while driving. There is a risk of
accident.
Never oil or grease wheel bolts. In the event
of damage to the threads, contact a qualified
specialist workshop immediately. Have the
damaged wheel bolts or hub threads
replaced/renewed. Do not continue driving.
Fitting a wheel
Z
359