Test mode for sewing machine
M4
M2
M1
M3
M5
Operation
Enter Test program.
Use the stitch width selector wheel (A) to go through the
diffrent test mode functions.
Mode 1: Needle position at Left/Centre/Right without feed.
After entering the test mode 2 all the diffrent sensors of the machine is de-activated (Machine will run wit-
hout thread).
Mode 2: Needle position at center without feed
Is used for checking the movement of the zig-zag step motor and centre position of the needle in straight
stitching. The zig-zag stepmotor calibrates and takes its Centre position.
Mode 3: Balance check
Machine will feed 2 mm, at center position, stitch 11 needles forward and backward.
Needle must always stop at the staring stitch
Mode 4: Bobbin thread brake sensor
Is for chrcking the bobbins sensor .Machine will feed 0.5 mm, at center position.
The top thread detection is deactivated.
Mode 5: align
Machine will feed 2.5 mm forward and 2.5 mm reverse, at z-z 7mm.
Singer Futura XL-400 , FQ-4
31