Honda 1999 Accord Coupe Owner's Manual page 82

HomeLink Universal Transmitter
Retraining a Button
To train an already programmed
transmitter button to operate a new
device:
1. Select the transmitter button you
want to train.
2. Press and hold the transmitter
button until the red light begins to
flash slowly (approximately 20
seconds).
3. While continuing to hold the
transmitter button, place the
remote control for the device near
the HomeLink transmitter.
4. Press and hold the button on the
remote control. Hold both buttons
until the red light begins to flash
rapidly.
5. Release both buttons. The
transmitter, should now be trained
to operate the device.
Instruments and Controls
Training With a Rolling Code
System
For security purposes, newer garage
door opening systems use a "rolling"
or variable code. If you know that
your garage door opener has a
rolling code, or you have been
unable to train the transmitter after
several attempts, use the following
procedure. You will need someone to
help you.
TRAINING
BUTTON
GARAGE DOOR
OPENER MOTOR/
CONTROL UNIT
1. Make sure you have properly
completed the "Training the
Transmitter" procedure.
2. Find the "Training" button on your
garage door opener motor/control
unit. The location will vary,
depending on the manufacturer.
The manufacturer's
documentation may help.