Hyundai 2010 Genesis Owner's Manual page 121

Features of your vehicle
Gate operator & Canadian program-
ming
During programming, your handheld
transmitter may automatically stop trans-
mitting. Continue to press the Integrated
HomeLink ® Wireless Control System but-
ton (note steps 2 through 4 in the
Standard Programming portion of this
document) while you press and re-press
("cycle") your handheld transmitter every
two seconds until the frequency signal
has been learned. The indicator light will
flash slowly and then rapidly after sever-
al seconds upon successful training.
Operating HomeLink ®
To operate, simply press and release the
programmed HomeLink
Activation will now occur for the trained
device (i.e. garage door opener, gate
operator, security system, entry door
lock, home/office lighting, etc.). For con-
venience, the hand-held transmitter of
the device may also be used at any time.
4 44
Reprogramming a single HomeLink
button
To program a new device to a previously
trained HomeLink
steps:
1. Press and hold the desired HomeLink
button. Do NOT release until step 4
has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
handheld transmitter 1 to 3 inches
away from the HomeLink
3. Press and hold the handheld transmit-
ter button. The HomeLink
light will flash, first slowly and then rap-
idly.
4. When the indicator light begins to flash
® button.
rapidly, release both buttons.
5. Press and hold the just-trained
HomeLink ®
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your new device
should activate.
®
® button, follow these
®
® surface.
® indicator
button and observe the red
Erasing HomeLink ® buttons
Individual buttons cannot be erased.
However, to erase all three programmed
buttons:
1. Press and hold the two
HomeLink ® buttons until the indicator
light begins to flash-after 20 seconds.
2. Release both buttons. Do not hold for
longer than 30 seconds.
The Integrated HomeLink ®
Control System is now in the training
(learn) mode and can be programmed at
any time following the appropriate steps
in the Programming sections above.
outer
Wireless