Toyota 2004 Matrix Owner's Manual page 145

Error messages
If the player malfunctions, your audio sys-
tem will display the following error mes-
sages.
"TIGHT TAPE": This message is dis-
played when the tape is tight and the
player cannot turn the tape hubs. Remove
the tape. Hold the tape with the open end
down and try to turn the right hub coun-
terclockwise with a pencil. Turn the tape
over and repeat. If the hubs do not turn
easily, your tape may be damaged and
should not be used in the player. Try a
new tape to make sure your player is
working properly.
"BROKEN TAPE": This message is dis-
played when the tape is broken. Try a
new tape.
"CLEAN PLAYER": This message is dis-
played when the cassette tape player
need to be cleaned. It will still play tapes,
but you should clean it as soon as pos-
sible to prevent damage to the tapes and
player. After cleaning the player, push and
hold the cassette tape eject button until
you hear a beep. "CLEANED" will appear
on the display.
'04 MATRIX_U (L/O 0307)
"WRAPPED TAPE": This message is dis-
played when the tape is wrapped around
the tape head. Attempt to get the cassette
out. Try a new tape.
If malfunction is not rectified, take your
vehicle to your Toyota dealer.
Cut tape bypass function
When you use the endless type tape
(head cleaner tape etc.), you must deacti-
vate the tape bypass feature.
To deactivate this feature:
1. Turn the ignition key to the "ACC" or
"ON" position, and the audio is off.
2. Push and hold the "TAPE/CD" button
for more than two seconds. "READY"
will appear on the display.
3. Insert the endless type tape.
The tape bypass feature will stay deacti-
vated until the cassette tape eject button
is pushed.
TONE (Manual tone adjustment function)
Push the "TONE" button to select the
bass, midrange or treble tone control posi-
tion. ("BASS", "MID", "TREB" will appear
on the display.) To adjust the tone, turn
"TUNE/SELECT" knob.
"BASS": Adjusts low−pitched tones. The
display ranges from −6 to +6.
"MID": Adjusts mid−pithed tones. The dis-
play ranges from −6 to +6.
"TREB": Adjusts high−pitched tones. The
display ranges from −6 to +6.
To adjusts all of the tone controls to the
middle position, push and hold the "TONE"
button for more than two seconds. "FLAT"
will appear on the display.
2004 MATRIX from Oct. '03 Prod. (OM12861U)
127