Subaru 2012 Impreza Owner's Manual page 190

3-76
Instruments and controls
and objects are out of the way of
the garage door or other device
to prevent potential harm or
damage.
. Do not use the HomeLink
less Control System with a gar-
age door opener that lacks the
safety stop and reverse feature
as required by applicable safety
standards. A garage door opener
which cannot detect an object,
signaling the door to stop and
reverse, does not meet these
safety standards. Using a garage
door opener without these fea-
tures increases risk of serious
injury or death. For more infor-
mation, consult the HomeLink
website at www.homelink.com or
call 1-800-355-3515.
CAUTION
When programming the HomeLink
Wireless Control System to operate
a garage door opener or an entrance
gate, unplug the device's motor
from the outlet during programming
to prevent motor burnout.
NOTE
. After programming your HomeLink
Wireless Control System for the de-
sired devices, retain the hand-held
transmitters for further programming
Wire-
®
or device testing in the event of a
problem.
. It is recommended that you insert a
new battery in the hand-held transmit-
ter of a device to ensure correct
programming.
! Garage door opener programming in
the U.S.A.
NOTE
When programming the HomeLink
Wireless Control System for a garage
®
door opener, it is suggested that you
park the vehicle outside the garage.
1. Unplug the motor of the garage door
opener from the outlet.
NOTE
®
If any of the HomeLink
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
®
1) HomeLink
2) HomeLink
3) HomeLink
®
2. Press and hold the two outer
HomeLink
3) until the indicator light begins to flash
(after approximately 20 seconds). Then
release both buttons.
3. Hold the end of the garage door
opener's hand-held transmitter between
1 and 3 inches (25 and 76 mm) away from
buttons are
the HomeLink
®
gram.
4. Simultaneously press and hold both
the hand-held transmitter button and the
desired HomeLink
lease the buttons until step 5 has been
completed.
button 1
®
button 2
®
button 3
®
buttons (button 1 and button
®
button you wish to pro-
®
button. DO NOT re-
®