Fuses Allocation Chart - Mercedes-Benz 2013 C-Class W204 Sedan Owner's Manual

Electrical fuses
364
Tow-starting (emergency engine
starting)
When tow-starting, it is important that you
observe the safety notes (
legal requirements in each respective coun-
try.
! Vehicles with automatic transmission
must not be tow-started. The transmission
may otherwise be damaged.
You can find information on "Jump-starting"
under ( Y page 359).
Before tow-starting the following conditions
must be fulfilled:
the battery is connected.
R
the engine has cooled down.
R
the exhaust system has cooled down.
R
X
Switch on the hazard warning lamps
( Y page 131).
X
Fit the towing eye (
X
Secure the rigid towing bar or the towing
rope.
X
Depress and hold the brake pedal.
X
Turn the key to position 2 in the ignition
lock.
X
Depress the clutch pedal fully, engage sec-
ond gear and keep the clutch pedal fully
depressed.
X
Release the brake pedal.
X
Tow-start the vehicle.
X
Release the clutch pedal slowly; do not
depress the accelerator pedal while doing
so.
X
When the engine starts, immediately
depress the clutch pedal fully and shift to
neutral.
X
Stop at a suitable place, paying attention to
road and traffic conditions.
X
Depress the parking brake.
X
Remove the rigid towing bar or towing rope.
X
Remove the towing eye (
X
Switch off the hazard warning lamps.
Y
page 361) and the
Y page 362).
Y page 362).
Electrical fuses
Important safety notes
G
WARNING
If you manipulate, bridge or replace a faulty
fuse with a fuse of a higher amperage, the
electric cables could be overloaded. This may
result in a fire. There is a risk of an accident
and injury.
Always replace faulty fuses with specified new
fuses of the correct amperage.
! Only use fuses that have been approved
for Mercedes-Benz vehicles and which
have the correct fuse rating for the system
concerned. Otherwise, components or sys-
tems could be damaged.
The fuses in your vehicle serve to disconnect
faulty circuits. If a fuse blows, all the compo-
nents on the circuit and their functions will
fail.
Blown fuses must be replaced with fuses of
the same rating, which you can recognise by
the colour and fuse rating. The fuse ratings
are listed in the fuse allocation chart.
If the newly inserted fuse also blows, have the
cause traced and rectified at a qualified spe-
cialist workshop, e.g. a Mercedes-Benz
Service Centre.
Before replacing a fuse
X
Secure the vehicle against rolling away
( Y page 187).
X
Switch off all electrical consumers.
X
Turn the key to position 0 in the ignition
lock and remove it (
or
X
On vehicles with KEYLESS-GO, make sure
the ignition is switched off (
All indicator lamps in the instrument cluster
must be off.
Y
page 167).
Y page 167).