Motorway Mode - Mercedes-Benz 2013 C-Class W204 Sedan Owner's Manual

Table of Contents

Advertisement

Not active: if you are driving at speeds above
40 km/h or switch off the turn signal or turn
the steering wheel to the straight-ahead posi-
tion.
The cornering lamp may remain lit for a short
time, but is automatically switched off after
no more than three minutes.

Motorway mode

Motorway mode increases the range of the
beam.
Active:
if you are driving at speeds above
R
110 km/h and do not make any large steer-
ing movements for 1,000 m.
if you are driving at speeds above
R
130 km/h.
Not active: if you are driving at speeds below
80 km/h following activation.
Extended range foglamps
The extended range foglamps reduce the
glare experienced by the driver and improve
the illumination of the edge of the carriage-
way.
Active: if you are driving at speeds below
70 km/h and you switch on the rear foglamp.
Not active: if, following activation, you are
driving at speeds above 100 km/h or if you
switch off the rear foglamp.
Adaptive Highbeam Assist
Important safety notes
G
WARNING
Adaptive Highbeam Assist does not recognise
road users:
who have no lights, e.g. pedestrians
R
who have poor lighting, e.g. cyclists
R
whose lighting is blocked, e.g. by a barrier
R
In very rare cases, Adaptive Highbeam Assist
recognises road users too late or not at all. In
this, or in similar situations, the automatic
main-beam headlamps will not be deactivated
or activated regardless. There is a risk of an
accident.
Always carefully observe the traffic conditions
and switch off the main-beam headlamps in
good time.
Adaptive Highbeam Assist cannot take into
account road, weather or traffic conditions.
Adaptive Highbeam Assist is only an aid. You
are responsible for adjusting the vehicle's
lighting to the prevailing light, visibility and
traffic conditions.
In particular, the detection of obstacles can
be restricted if there is:
poor visibility, e.g. due to fog, heavy rain or
R
snow
dirt on the sensors or the sensors are
R
obscured
General notes
You can use this function to set the head-
lamps to change between dipped beam and
main beam automatically. The system recog-
Exterior lighting
Z
133

Advertisement

Table of Contents
loading

Table of Contents