Checking The Engine Coolant Level - Toyota 2003 Celica Owner's Manual

Oil identification marks
Either or both API registered marks are
added to some oil containers to help
you select the oil you should use.
The API Service Symbol is located any-
where on the outside of the container.
The top portion of the label shows the oil
quality by API (American Petroleum Insti-
tute) designations such as SL. The center
portion of the label shows the SAE viscos-
ity grade such as SAE 5W−30. "Energy−
Conserving" shown in the lower portion,
indicates that the oil has fuel−saving ca-
pabilities.
The ILSAC (International Lubricant Stan-
dardization and Approval Committee) Certi-
fication Mark is displayed on the front of
the container.
206
'03MY CELICA U (L/O 0208)
To ensure excellent lubrication
mance for your engine, the
Genuine Motor Oil" range is available,
which has been specifically tested and
approved for all Toyota engines.
Please contact your Toyota dealer for fur-
ther details of the "Toyota Genuine Motor
Oil" range.
Checking the engine coolant
level
Look at the see−through coolant reser-
voir when the engine is cold. The cool-
ant level is satisfactory if it is between
the "FULL" and "LOW" lines on the
reservoir. If the level is low, have your
Toyota dealer add ethylene−glycol type
coolant for proper corrosion protection
of aluminum components.
The coolant level in the reservoir will vary
with engine temperature. However, if the
level is on or below the "LOW" line, you
should have your Toyota dealer add cool-
ant.
Always use ethylene−glycol type coolant
perfor-
for a proper corrosion protection of alumi-
"Toyota
num components. See information in the
next column.
If the coolant level drops within a short
time after replenishing, there may be a
leak in the system. Visually check the
radiator, hoses, drain cock and water
pump.
If you can find no leak, have your Toyota
dealer test the cap pressure and check
for leaks in the cooling system.
2003 CELICA from Aug. '02 Prod. (OM20809U)