Toyota 2003 Celica Owner's Manual page 103

TURNING ON THE SYSTEM
To operate the cruise control, press the
"CRUISE ON−OFF" button. This turns the
system on. The indicator light in the in-
strument panel shows that you can now
set the vehicle at a desired cruising
speed. Another press will turn the system
completely off.
CAUTION
To avoid accidental cruise control en-
gagement, keep the "CRUISE ON−
OFF" switch off when not using the
cruise control.
'03MY CELICA U (L/O 0208)
SETTING AT A DESIRED SPEED
On vehicles with automatic transmission,
the selector lever must be in the "D" posi-
tion or the gear position must be "3" or
"4" in M mode before you set the cruise
control speed.
Bring your vehicle to the desired speed,
push the lever down in the "SET/COAST"
direction and release it. This sets the ve-
hicle at that speed. If the speed is not
satisfactory, tap the lever up for a faster
speed, or tap it down for a slower speed.
Each tap changes the set speed by 1.6
km/h (1.0 mph). You can now take your
foot off the accelerator pedal.
If you need acceleration—for example,
when passing—depress
pedal enough for the vehicle to exceed
the set speed. When you release it, the
vehicle will return to the speed set prior
to the acceleration.
CAUTION
For manual transmission:
While driving with the cruise control
on, do not shift to neutral without
depressing the clutch pedal, as this
may cause engine racing or over−rev-
ving.
CANCELLING THE PRESET SPEED
You can cancel the preset speed by:
a. Pulling the lever in the "CANCEL" di-
rection and releasing it.
b. Depressing the brake pedal.
c. Depressing the clutch pedal (manual
transmission).
If the vehicle speed falls below about 40
km/h (25 mph), the preset speed will auto-
matically cancel out.
If the vehicle speed drops 16 km/h (10
mph) below the preset speed, the preset
speed will also automatically cancel out.
2003 CELICA from Aug. '02 Prod. (OM20809U)
the accelerator
103