Table of Contents
Advertisement
Notes on Use
Usage locations
Printer usage location
•
Do not use in the following locations:
• Locations subject to a lot of dust or lint, as this may lead to inability to print cleanly.
• In direct sunlight, near an air conditioner, or in any other location where temperature
may rise above 35 °C (95 °F) or fall below 5 °C (41 °F). There is a risk of causing
malfunction, deformation, or damage to the printer.
• On a piano or a carpeted surface. There is a risk of causing damage or discoloration.
• Where it can be exposed to tobacco smoke. There is a risk of causing the printer to
malfunction.
•
Keep away from magnetic and/or electronic hardware.
In order to prevent adverse electromagnetic effects, be sure to operate as far away as
possible from the following type of appliances.
• Mobile phones, microwave ovens, electronic game units and stereo speakers.
•
Do not use the printer vertically.
This may cause the printer to malfunction.
If the printer's inner components overheat
When the ambient temperature is high or when continuous printing has been performed,
printing operations may temporarily halt in order to keep the internal temperature of the
printer from rising. Printing will automatically resume when the internal temperature of the
printer goes down. Ensure that the printer is used in a well-ventilated location.
When ambient temperatures are low
To maintain high quality image output, the printer does not begin printing until the internal
temperature has warmed up, so it may take some time before printing starts. Printing starts
automatically once the temperature has risen sufficiently.
To prevent the printer deformation and keep the case finish
Do not spill or allow any volatile solvents, such as benzine, paint thinner, or other solvents
or insecticide to come in contact with the printer. Also, do not maintain contact with the
printer by rubber or vinyl-coated materials for an extended period of time. This may damage
the surface of the printer or cause the case finish to peel.
Required space during printing
Paper is ejected and inserted from the rear panel of this printer during printing.
Do not place any objects within 220 mm (8.7") of the rear panel of the printer. Use the
printer on a flat surface, not doing so may lead to paper jams.
Top view
220 mm (8.7")
Paper cassette
Continued on next page
9
Advertisement
Table of Contents
