Panasonic aw-e350p Operating Instruction page 40

O COLOR PHASE ADJUSTMENT
Supply the output signal (split color bar) from the
color special effect generator to a color monitor or
vectorscope. Adjust the color phase of the camera.
[ADJUSTMENT by CAMERA or multi hybrid control panel]
1. Press the NO/BAR switch for over 5 seconds for the
color bar mode.
2. Select [G/L Adjustment] on the main menu, then
select [SC Coarse] on the sub menu.
3. Make coarse adjustment with the YES/ABC switch
and the NO/BAR switch.
4. Select [SC Fine] on the sub menu. Perform fine
adjustment with the YES/ABC switch and the
NO/BAR switch.
For details on the menu operations using the multi hybrid
control panel, refer to the Operating Instructions of the
multi hybrid control panel.
Color bar of
camera
Sprit line
Color bar of special
effects generator
- 40 -
[ADJUSTMENT with RCU]
Use the subcarrier phase coarse adjustment control and
subcarrier phase fine control.
* It is recommended that a vectorscope be used for
maximum accuracy in color phase adjustment.
CAUTION:
When color phase adjustment is required using RCU,
color bar/camera selector switch should be set to BAR.
Color phase cannot be adjusted if the switch is in the
CAM position. After adjustment set color bar/camera
selector switch back to CAM.