Yamaha RX-V465 Owner's Manual page 53

Problem
The sound suddenly The protection circuitry has been activated
goes off.
because of a short circuit, etc.
The sleep timer has turned off this unit.
Sound is heard from The playback component or speakers are
the speaker on one not connected properly.
side only.
The speaker level settings are incorrect.
Only the center When a monaural source sound field
speaker outputs
program is applied, sound of all channels
substantial sound. are output from the center speaker for
some surround decoders.
No sound is output
Output from that speaker is disabled.
from a specific
speaker.
The volume of that speaker is set to
minimum in Speaker Setup in the Setup
menu.
This unit or speaker is malfunction.
No sound is heard This unit is in the "STRAIGHT" mode
from the surround and a monaural source is being played
speakers.
back.
Sound may not be output from certain
channels depending on input sources or
sound field programs.
No sound is heard "Bass Out" of "A)Config" in "Speaker
from the subwoofer.
Setup" of the setup menu (Speaker
Setup→2 Manual Setup→A)Config) is set
to "Front" when a Dolby Digital, DTS or
AAC signal is being played.
"Bass Out" of "A)Config" in "Speaker
Setup" of the setup menu (Speaker
Setup→2 Manual Setup→A)Config) is set
to "SWFR" or "Front" when a 2-channel
source is being played.
The source does not contain low
frequency signals.
No sound is heard "EXTD Surround" in the OPTION menu
from the surround is set to "Off," or an input signal does not
back speakers.
contain a surround back flag with "EXTD
Surround" set to "Auto."
Cause
Check that the speaker wires are not touching each
other and then turn this unit back on.
Turn on this unit, and play the source again.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust "B)Level" settings.
Try another sound field program.
Check the Speaker indicators on the front panel
display. If the corresponding indicator is turned off,
try the following.
1) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker. Select another sound field
program.
3) "None" may have been selected for that speaker on
this unit. Display Speaker Setup in the Setup menu
and enables output of that speaker.
Display Speaker Setup in the Setup menu and adjust
the volume (2 Manual Setup→B)Level).
Check the Speaker indicators on the front panel
display. If the corresponding indicator lights up,
connect another speaker and check if sound is output.
If sound is not output, this unit may be malfunction.
Press LSTRAIGHT or the jSTRAIGHT on the
remote control to turn off the "STRAIGHT" mode.
Try another sound field program.
Set "Bass Out" to "SWFR" or "Both."
Set "Bass Out" to "Both."
Set "EXTD Surround" other than "Off" or "Auto."
Troubleshooting
Remedy
See
page
—
—
11
43
24
6, 21, 24,
42
43
6, 10
27
24
41
41
42
49
En