Panasonic CF-T1 Series Operating Instructions Manual page 11

CAUTION
Remember this password! If the password is forgotten, Windows cannot be
operated.
Enter the correct date, time and the time zone, then select [Next].
6
You can also complete these settings at a later time. In this case, set [Date and
Time] in [Start] - [Settings] - [Control Panel] - [Date/Time].
At [Networking Settings], select [Typical settings], then select [Next].
7
At [Workgroup or Computer Domain], select [No, this computer is not on a
8
network, or is on a network without a domain], then select [Next].
The computer will restart.
At [Welcome to the Network Identification Wizard], select [Next].
9
At [Users of This Computer], select [Users must enter a user name and pass-
10
word to use this computer], then select [Next].
Select [Finish].
11
Enter your administrator password and select [OK].
12
<Only for models with touchscreen>
If the cursor can not be pointed correctly with the stylus, perform [Calibration] in
[Start] - [Settings] - [Control Panel] - [Mouse] - [TouchScreen].
Windows XP
CAUTION
Do not press any key or move the touch pad until [Windows XP Professional
Setup] is displayed.
At [Welcome to the Windows XP Setup Wizard], select [Next].
1
After reading the agreement, select [I accept this agreement] or [I don't accept this
2
agreement], then select [Next].
NOTE
If [I don't accept this agreement] is selected, the Windows setup will be aborted.
Select settings for your region, then select [Next].
3
Enter your name and organization and then select [Next].
4
Enter your computer name and administrator password and then select [Next].
5
CAUTION
Remember this password! If the password is forgotten, Windows cannot be
operated. You can create a password reset disk beforehand (
Enter the correct date, time and the time zone, then select [Next].
6
You can also complete these settings at a later time. In this case, set [Date and
Time] in [start] - [Control Panel] - [Date, Time, Language, and Regional Options].
At [Networking Settings], select [Typical settings], then select [Next].
7
At [Workgroup or Computer Domain], select [No, this computer is not on a
8
network, or is on a network without a domain], then select [Next].
The computer will restart.
Enter your administrator password and select
9
<Only for models with touchscreen>
If the cursor can not be pointed correctly with the stylus, perform [Calibration] in
[start] - [Control Panel] - [Printers and Other Hardware] - [Mouse] - [TouchScreen].
page 13).
.
11