Panasonic CF-T1 Series Operating Instructions Manual page 10

First-time Operation
Latch
2
1
DC-IN Jack
3
1
2
Power Switch
Power Indicator
10
4
Open the display
Slide the latch located at the front.
1
Lift open the display.
2
CAUTION
Do not open the display wider than necessary (160° or more).
Do not apply excessive pressure to the glass part of the display. Also, do
not hold the glass part when opening or closing the display.
5
Connect your computer to a power outlet
DC IN 16V
The battery pack will be charged automatically.
Charging Time: Approx. 3 hours
Glass Part
(Varies depending on the usage conditions.)
CAUTION
Be sure the AC adaptor is connected until completing Step 8 on page 12.
When using the computer for the first time, do not connect any peripheral de-
vice except the battery pack and AC adaptor to the computer.
Handling the AC adaptor
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adaptor with your computer. Using an AC adaptor
other than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
Problems such as sudden voltage drops may arise during periods of thunder and
lightning. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless running from the battery
pack alone.
6
Turn your computer on
Slide the power switch and hold it for approximately one second until the power indi-
cator turns on before releasing it.
CAUTION
Do not slide the power switch and hold it for more than four seconds; this will
cause the power to be turned off forcibly.
Do not slide the power switch repeatedly.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
7
Setup Windows
Moving the cursor ( ) or clicking buttons can be performed with the touch pad (
Windows 2000
CAUTION
Do not press any key or move the touch pad until [Windows 2000 Professional
Setup] is displayed.
At the [Welcome to the Windows 2000 Setup Wizard], select [Next].
1
After reading the agreement, select [I accept this agreement] or [I don't accept this
2
agreement], then select [Next].
NOTE
If [I don't accept this agreement] is selected, the Windows setup will be aborted.
Select settings for your region, then select [Next].
3
Enter your name and organization and then select [Next].
4
Enter your computer name and administrator password and then select [Next].
5
page 17).